Universal Output; Usb Interface; Analogue Output - WIKA CPH6300 Betriebsanleitung

5. Commissioning, operation
4. Press [STORE/QUIT] button.
⇒
Confirm the selection, end of the "Delete" function.

5.6 Universal output

The universal output can also be used as a USB interface (for USB6300 interface
adapter) or as an analogue output (0 ... 1 V). If the output is not required, it should be
deactivated (
Connector assignment
4
3

5.6.1 USB interface

With a USB6300 galvanically isolated interface converter (WIKA accessory), the
instrument can be connected directly to a USB interface of a PC. The transmission
is made in a binary-coded format and is protected against transmission errors by an
extensive safety mechanism (CRC).
As operation and evaluation software for the integrated logger function, GSOFT software
is suitable.

5.6.2 Analogue output

At the universal output connector, an analogue voltage of 0 ... 1 V can be tapped (setting
Out dAC
With DAC.0
It must be ensured that the analogue output is not loaded too heavily, otherwise the
output value can be corrupted and the power consumption of the instrument increases
correspondingly. Loads up to approx. 100 kΩ are harmless.
If the display exceeds the value set with
If the display drops below the value set with
WIKA operating instructions, model CPH6300
Downloaded from www.Manualslib.com
Out oFF ) since this strongly reduces the battery usage.
1 +U , analogue output
DAC
2 TxD / RxD (3.3 V logic)
1
2
3 GND
4 external supply +5 V, 50 mA
CAUTION!
Only suitable adapter cable is permitted (WIKA accessory)!
).
and the analogue output can be easily scaled.
DAC.1
manuals search engine
DAC.1 , then 1 V will be output.
DAC.0
, then 0 V will be output.
EN
29