WIKA CPH6300 Betriebsanleitung Seite 28

5. Commissioning, operation
Each save operation will be signalled briefly on the display with "St.XXXXX".
XXXXX is the number of the data set.
Lo66 FULL
EN
Lo.Po =
5.5.2.2 Stopping the logger recording:
1. Press the [STORE/QUIT] button for 2 seconds.
⇒
If a recording is running, the stop menu is displayed.
2. Press the [▲] or [▼] button.
⇒
Change the selection.
SToP no
SToP yes
3. Press [STORE/QUIT] button.
⇒
Confirmation of the selection, logger recording ended.
5.5.2.3 Clearing logger recording
1. Press the [STORE/QUIT] button for 2 seconds.
⇒
In the case where there is logger data present, and the recording has already
been stopped,
2. Press the [▲] or [▼] button.
⇒
Change the selection to
3. Press the [▲] or [▼] button.
⇒
Change the selection.
CLr no
CLr ALL
CLr LASt
28
Downloaded from www.Manualslib.com
Shows in the event the logger memory is full. The recording will be
stopped automatically.
Appears with the low-power logger function.
on
As soon as the logger memory is full, the instrument switches itself off.
Do not stop recording (cancel the process).
Stop recording.
If you try to switch off an instrument during a logging cycle, you will
automatically be asked if you wish to stop recording.
The instrument can only be switched off after the recording has been
stopped.
The auto power-off function is deactivated during recording!
Lo66 rvn
Lo66 CLr
Do not delete (cancel the process).
Delete all data sets.
Clear the last data set.
manuals search engine
is shown
in order to call the "Delete" function.
WIKA operating instructions, model CPH6300