Stryker Precision AC Bedienungsanleitung Seite 14

Sterilization
After performing the cleaning instructions specified above,
perform one of the following sterilization cycles:
Steam
Steam sterilization is intended only for couplers marked
AUTOCLAVE. Steam sterilizing couplers that do not
bear this marking will result in non-sterile product and
product damage.
Refer to the "Product Description and Intended Use"
section for the location of the AUTOCLAVE marking on
the Precision AC Coupler.
1. Clean and prepare the coupler as recommended in this user
guide.
2. If using a sterilization tray (optional), follow any additional
instructions provided with the tray. Use only trays that are
compatible with steam sterilization.
3. Double wrap the coupler (or tray) prior to sterilization.
4. Sterilize the coupler using the parameters below.
Note: The water used in the autoclave process must meet
standards for clean steam per AAMI ST79 Annex M – Steam
Quality.
• For routine reprocessing with steam sterilization, use the
following Gravity or Pre-Vacuum cycles.
Gravity
Wrapping
Temperature
Sterilization Time
Dry Time
Pre-Vacuum
Wrapping
Temperature
Sterilization Time
Dry Time
• Immediate-use steam sterilization (IUSS, or "Flash") is intended
only for emergency situations. In the event that immediate-
use steam sterilization is required, the following instructions
should be used.
"Flash" Pre-Vacuum
Wrapping
Temperature
Sterilization Time
Dry Time
EN-10
Immediate-use steam sterilization should only be
used in carefully selected clinical situations (e.g. an
instrument needed for a case falls on the floor and
no replacement instrument is available). IUSS should
not be used due to inadequate inventory.
Double
132°C (270°F)
15 minutes
12 minutes
Double
132°C (270°F)
4 minutes
25 minutes
None
132°C (270°F)
4 minutes
None
134°C (274°F)
10 minutes
134°C (274°F)
3 minutes
30 minutes
134°C (274°F)
3 minutes