General Instructions; Batteries; Function Description - Truma Mover XT4 Gebrauchsanweisung, Einbauanweisung

General instructions

The Mover® XT4 has been designed to cope with inclines of
up to approx. 10 % bearing a gross weight of 3100 kg on a
suitable surface.
Depending on the weight of the caravan, the Mover® XT4
may not be able to overcome obstacles more than about
5 cm in height without auxiliary equipment (please use ascent
chocks).
As a result of the characteristic properties of a radio signal, it
may be interrupted by terrain / objects. This reduces reception
quality in small areas around the caravan, as a result of which
the operation of the Mover® XT4 may be briefly interrupted.
When the Mover® XT4 is switched off using the remote
control, the control unit remains in standby for one hour.
In order to switch off completely the battery must be discon-
nected or an isolating switch installed.

Batteries

Recommended battery capacities
Button cell technology
Gel / AGM
Lead-acid battery (liquid electrolyte)
Starter batteries are not suitable
Batteries with greater capacity allow the equipment to
be used for longer.
Charger
For optimum battery charging we recommend the Truma BC 10
charger, which is suitable for all battery types up to 200 Ah.
Battery care (including maintenance-free
batteries)
In order to achieve a long battery service life, attention must
be paid to the following points:
– Batteries should be fully charged before and after removing
power,
– for stationary periods of longer than 24 hours, interrupt
power circuit (e.g. using circuit breaker or by disconnecting
the battery poles),
– for longer stop periods the battery must be disconnected
and charged for 24 hours at least every 12 weeks.
In winter, store fully charged battery in a cool and frost-free
place and recharge at regular intervals (every 12 weeks).

Function description

Always observe the operating instructions and the
"Safety instructions" prior to starting! The vehicle owner
is responsible for correct operation of the device.
Please note that the Mover® XT4 is only suitable for
twin-axle trailers.
The Mover® XT4 is a manoeuvring system which allows a cara-
van to be manoeuvred without the aid of the towing vehicle.
It consists of four separate drive assemblies, each with its
own 12 V DC motor. These units are mounted on the frame
of the vehicle in the immediate vicinity of the wheels, and are
connected by a lateral bar.
Once the drive rollers have been engaged using the remote
control, the Mover® XT4 is ready for operation. It is operated
exclusively via the remote control, which transmits radio sig-
nals to the control unit. A separately installed 12 V lead-acid
battery or suitable lead-gel battery (not supplied) provides the
control unit with electrical power.
at least 55 Ah
at least 70 Ah
at least 80 Ah
17