General Instructions; Batteries; Function Description - Truma Mover XT Gebrauchsanweisung

General instructions

The Mover® XT has been designed to cope with inclines of up
to approx. 25 % bearing a gross weight of 1200 kg or 13 %
bearing a gross weight of 2300 kg on a suitable surface.
The Mover® XT2 has been designed to cope with inclines of
up to approx. 25 % bearing a gross weight of 1200 kg or 10 %
bearing a gross weight of 2400 kg on a suitable surface.
Depending on the weight of the caravan, the Mover® XT / XT2
may not be able to overcome obstacles more than about
3 cm in height without auxiliary equipment (please use ascent
chocks).
As a result of the characteristic properties of a radio signal, it
may be interrupted by terrain / objects. This reduces recep-
tion quality in small areas around the caravan, as a result of
which the operation of the Mover® XT / XT2 may be briefly
interrupted.
When the Mover® XT / XT2 is switched off using the re-
mote control, the control unit remains in standby. In or-
der to switch off completely the battery must be disconnected
or an isolating switch installed.

Batteries

For optimum operation we recommend the Truma Mover®
PowerSet, which contains batteries with button cells and an
appropriate charger. So-called drive, lighting and gel batteries
with sufficient capacity are also suitable.
Recommended battery capacities
Button cell technology
Gel / AGM
Lead-acid battery (liquid electrolyte)
Starter batteries are not suitable
Batteries with greater capacity allow the equipment to
be used for longer.
Charger
For optimum battery charging we recommend the Truma
BC 10 charger, which is suitable for all battery types up to
200 Ah.
Battery care (including maintenance-free
batteries)
In order to achieve a long battery service life, attention must
be paid to the following points:
– Batteries should be fully charged before and after removing
power,
– for stationary periods of longer than 24 hours, interrupt
power circuit (e.g. using circuit breaker or by disconnecting
the battery poles),
– for longer stationary periods, the battery must be discon-
nected and charged for 24 hours at least every 12 weeks.
In winter, store the fully charged battery in a cool and
frost-free place and recharge at regular intervals (every
12 weeks).

Function description

Always observe the operating instructions and the
"Safety instructions" prior to starting! The vehicle owner
is responsible for correct operation of the device.
Please note that the Mover® XT is only suitable for sin-
gle-axle trailers, while the Mover® XT2 is only suitable
for dual-axle trailers.
The Mover® XT / XT2 is a manoeuvring system which allows
a caravan to be manoeuvred without the aid of the towing
vehicle.
It consists of two separate drive assemblies, each with its
own 12 V DC motor. These units are mounted on the frame
of the vehicle in the immediate vicinity of the wheels, and are
connected by a lateral bar.
Once the drive rollers have been engaged using the remote
control, the Mover® XT / XT2 is ready for operation. It is op-
erated exclusively via the remote control, which transmits
radio signals to the control unit. A separately installed 12 V
lead-acid battery or suitable lead-gel battery (not supplied)
provides the control unit with electrical power.
at least 38 Ah
at least 48 Ah
at least 75 Ah
17