en - Installation and connection
Removing the transport safety device
Before use, the transport safety device must be removed from the heater plate. Remove
the transport safety device by dismantling the brackets (shown below) in both side
columns.
Transport safety device in the right-hand side
column.
Before transporting the ironer again, the transport safety device must be refitted.
Store the transport safety device in the side column
Keep the transport safety device for subsequent use. There are holes drilled into the base
of the left-hand side column to secure the transport safety device.
Securing the transport safety device for storage in the left-hand side column.
Screw the transport safety device to the base of the left-hand side column for storage.
80
Transport safety device in the left-hand side
column.