eta GUSTUS II Bedienungsanleitung Seite 49

GB
– A small amount of food will remain on the grater after each use. This is normal
and does not establish a reason for filing a complaint.
– Cut large pieces into smaller ones so that they can be put into the hopper.
– First remove peels if processing citrus fruits.
– Input the food gradually and continuously.
– Do not chop the food too finely. Sufficiently fill the feeding tube to prevent slipping
the food away in processing.
– Set low/medium speed when processing soft food, such as cucumbers. To process
harder food, such as carrot or hard cheese, set the medium/high/maximum speed.
– Use low speed to grate soft food, otherwise it becomes mushy.
– If you are chopping hard cheese or chocolate, work for a short time, because the food
heats up, becomes softer and may get lumpy.
– Before slicing cabbage, cut it into hunks and remove the cabbage stalks.
– When slicing or grating, the pieces of the processed food will be shorter if input
vertically, not horizontally.
III.5) Glass blender (F)
Description (Fig. 10)
G1 – Container lid
G2 – Container support
G3 – Knife
– Do not let the blender running without any food!
– Do not remove the knife support G2 from the glass container!
– Never remove the container lid G1 when the motor unit is running!
– Never pour boiling liquids in the container.
– Before removing the blender lid or container, wait until the rotating parts completely stop.
– When the blender is in the state of idle operation, e.g. the blade fails to touch the foods,
unplug the unit until the foods have been relaxed.
Assembly
Assemble the blender and attach it to the blender mount A9 according to Figures 10 a 11.
Of the plug for adding liquids G5 you can also insert the in the opening in the lid if you are
going to use it. Apply reverse sequence to disassemble the unit and to remove it from the
mount.
Before the first use
We recommend washing the glass container before using it for the first time. The knife
section is treated with oil not harmful to health for technological reasons. Therefore first
fill in the container with warm water (max. 50 °C) with a small amount of detergent. Then
put the container on the food processor, set the maximum rotational speed and run for 1
minute. Then rinse the container with clear water.
Use
Remove the lid, put or pour the food into the container and replace the lid. We recommend
that you always switch on the blender to minimum revolutions and then gradually increase the
performance as required.
Tips
G4 – Knife sealing
G5 – Removable stopper
G6 – Glass container
Safety hints and tips
49 / 103