Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.3 Wheel installation
Model
CORSA - XC RETRO
ALL MOUNTAIN - Z1 - 4X
DIRT JUMPER - 66 - 888
Table 3 - Maximum tire dimension
In the event you need to install wheels with dimensions
larger than those specifi ed in Table 3, above, you must
verify that:
•
The tire turns freely;
•
The tire does not make any contact with the brake arch or
V-Brake system;
•
The distance between the infl ated tire and the lower part
of the lower crown is at least four (4) mm when the forks'
legs are fully compressed.
Wheel axle securing
system with standard
dropouts
CORSA
XC RETRO
ALL MOUNTAIN
DIRT JUMPER
Table 4 - Wheel securing systems
56
Max tire dimension
2,2" x 26"
2,8" x 26"
Wheel axle securing system with 20 mm
diameter
through-hole axle
ALL MOUNTAIN
Z1
DIRT JUMPER
3.4 Wheel axle securing system
The system for securing the wheel axle to the fork sliders
can be standard, which uses the traditional advanced
dropouts, or have a 20 mm diameter through-hole axle or
with QR quick release axle (see Table 4 below).
Forks that are created for more intensive use are provided
with a wheel fastening system, which originates from the
motocross application and uses a 20 mm axle.
The new QR system allows combined hardness and easy
installation.
3.4.1 Wheel installation on a fork with standard
securing system
CORSA
XC RETRO
DIRT JUMPER
Install the wheel in compliance with the wheel manufacturer's
instructions. For correct fork function after installing the
wheel, you will need to:
•
Check the fork-wheel alignment by fully compressing the
fork a few times. The wheel should not make contact with,
or come close to any portion of the fork.
•
Lift the front of the bicycle, and spin the wheel a few times
to verify correct alignment and spacing with the disk brake
or the V-Brake brake pads. Check the owner's manual of
the brake system for the proper specifi cations.
66
888
ALL MOUNTAIN
Wheel axle securing
system with QR quick
release axle
ALL MOUNTAIN
4X
Quicklinks ausblenden:
Werbung
Kapitel
