appliance (see table page 6: amount of ingre-
dients/recipe preparation time/temperature/
type of accessories).
• Allow the motor to cool down for half an
hour.
• Restart the appliance by pressing on the 'Start
/Stop/Reset' button
CLEANING YOUR APPLIANCE
• The appliance should not be immersed.
Never put the motor unit (A) under running
water.
Once you have finished using it, disconnect
the appliance.
• Clean the bowl immediately after use to
avoid staining.
• Press the locks (D2) then lift the bowl
assembly (D).
• Place the bowl on a flat surface.
• Unlock the lid by rotating one quarter of a
turn clockwise. Carefully remove the lid.
• The lid elements (gasket, gasket holder
and lid) can be dismantled. Once the parts
have cooled, unclip the lid's gasket holder
by sliding the end of the cleaning brush
handle (I) between both elements and safely
applying pressure to separate them (see
Fig. 15).
• Take care with the knives of the ultrablade
blade (F1) and the kneading / grinding
knife (F4) when you are cleaning them
and when you empty the bowl, they are
extremely sharp.
• When the parts have cooled down:
- dismantle the spindle (D3), the seal (D4) and
the locking ring (D6) (See Fig. 13).
- clean the bowl (D), the spindle (D3), the
seal (D4), or the XL base accessory (D5)
and the seal (D4),the locking ring (D6),
the accessories (F1), (F2), (F3), (F4), (F5),
the steam regulator cap (E1), the lid (E2),
the seal holder (E3) and the seal (E4)
using a sponge and some soapy water.
• Rinse these different parts under running
water.
for two seconds.
(B7)
Your appliance is now ready to be used again.
For further information, please contact cus-
tomer services (see details in the guarantee
booklet).
• If there is a build up of limescale in the bowl,
use a damp sponge and, if necessary, white
vinegar or cleaning products suitable for
stainless steel.
• For food stuck in the bowl, leave the bowl
to soak for several hours in water with a
little washing up liquid and dishwashing
detergent and scrape, if necessary, with a
spatula
or with the abrasive side of a
(G)
sponge.
• To clean the motor unit (A), use a damp
cloth. Dry carefully.
• To help you with cleaning, the bowl, lid
assembly and accessories are dishwasher
safe, with the exception of the spindle
(D3 and D4) the XL base accessory (D5 and
D4) and the locking ring (D6) (See Fig. 14).
• The accessories, the detachable spindle and
the parts of the lid may become slightly
discoloured with certain ingredients such
as curry, carrot juice, etc; this does not
represent any danger for your health or for
the operation of your appliance. To avoid
this, clean these parts immediately after
use.
• Before using the bowl (D), make sure that
the electrical contacts under the bowl are
clean and dry.
•
To avoid altering the materials of the bowl
(D), ensure that you respect the instructions
for use of your dishwasher, do not increase
the dose of dishwasher salt or dishwashing
products.
29
EN