Using Your Appliance - Moulinex Ovatio 3 Maxipress A BT6 Bedienungsanleitung

Wiring instructions for U.K and Ireland
only :
APPLIANCES WITH FITTED PLUG
Important : For your convenience this
appliance is supplied complete with a plug
incorporating a 3 amp fuse.
In the event of replacing a fuse in the plug
supplied, a 3 amp fuse approved by ASTA to
BS1362 must be used.
If the socket outlets are not of the 13A BS 1363
type, and therefore do not accept the plug
connected to this appliance, cut off the plug.
When cut off, this plug is a shock hazard if
inserted into a socket outlet and must
therefore be disposed of safely.
If the fuse cover is detachable, never use the
plug with the cover omitted. Replacement
covers can be obtained from your service
agent.
Fit the appropriate plug according to the ins-
tructions in paragraph "Fitting a plug". With
alternative plugs a 5 amp fuse must be fitted
either in the plug or adaptor or at the main
fuse box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
Any error in connecting the appliance
invalidates the guarantee. Neither wire
must be connected to the earth terminal
of a three pin plug.
The wires in the mains lead are coloured in
accordance with the following code:
BLUE : NEUTRAL
BROWN : LIVE
If the colours do not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked with
the letter 'N' or coloured black. The wire which
is coloured BROWN must be connected to the
terminal which is marked with the letter 'L' or
coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the requirements
of the EEC Directive (89/336/EEC).
- Handle the blades carefully, they are
extremely sharp.
- You must remove the blades (D) and the
spindle (C) before emptying the bowl of
its contents.
- Never touch any parts whilst they are still
moving.
- Always use the pusher to push food down
the feeder tube. Never use your fingers, a
fork, spoon, knife or any other utensil.
- Never use your appliance empty or if you
notice a fault (damaged lead etc.)
Changing the Mains Lead
If the mains lead or the plug are damaged, do
not use your appliance. In order to avoid any
accident, they must be replaced by an appro-
ved Moulinex Centre (see list in the leaflet
"Moulinex Service").
- Do not allow the mains lead to hang over
the edge of your worktop or table.
- Use only Moulinex attachments.
- Always unplug the appliance when you have
finished using it.
- This appliance is for domestic use only.

Using your appliance

- Plug the appliance in.
- Pulse button: Press the button (A3)
intermittently for greater control of certain
processes.
- Continuous action button: Turn the button
(A4) round to «1».
- Switching off: Turn the button (A4) to where
it is marked «0».
- Speed selector (A2): choose the
recommended speed or vary the speed
during processing.
Functions of your food
processor
. Assembling the bowl/drive(B3)
1
The bowl/drive set is used with all the
accessories:-
- Place the joint (B5) in the middle of the
bowl - the flat side of the joint facing the
bottom of the bowl
- Place the drive (B4) on the joint (B5)
- Lock the drive (B4) with the nut (B6) as far
as it will go.
- Dismantle and clean all parts after use.
MIXING, BLENDING, CHOPPING, KNEA-
2
DING LARGE QUANTITIES
Depending on the type of food, the processor
bowl (B) allows you to process up to 1500g of
food.
A
CCESSORIES USED
- Processor bowl and accessories(B), spindle
(C) and blades(D):
. metal blade (D1) for blending and chopping
10
: