Product Functionality - EKOM DK50-10 series Handbuch

DK50-10
8.2.3. Filters set
Compressors may be equipped with a filters set on the compressed air outlet if specified. The set of
filters may be equipped with a pressure regulator. Filters set are suitable accessories for all the
compressors specified above.
NOTE : If a higher level of air filtration is required, this specification must be agreed on with the
supplier and made clear in the order.
Type Use
FS 20FR DK50-10Z
FS 20M
FS 20MR
FS 20S
FS 20SR
FS 21S DK50-10Z/M
FS 21SR
8.2.4. Condensation and filtration unit (KJF)
The compressor may be additionally fitted with a condensation and filtration unit (KJF-1 or KJFR-1).
The KJF-1 or KJFR-1 ensure that the compressed air from the air tank is cooled in the cooler and
the condensate is captured in the filter and automatically separated from the pneumatic distribution
system. The compressed air is filtered at the same time.
Type Use
KJF-1
DK50-10Z
KJFR-1

PRODUCT FUNCTIONALITY

Compressor (Fig. 1)
The air pump (1) draws in atmospheric air through an inlet filter (8) and compresses it through a
non-return valve (3) into an air tank (2) from which the device draws compressed air. If the pressure
in the air tank drops to the switch-on pressure, the pressure switch (4) turns on the compressor and
the compressor supplies compressed air into the air tank until it reaches the switch-off pressure,
when the compressor switches off. The pressure hose is vented through the relief solenoid valve
(13) once the air pump is shut off. The safety valve (5) prevents the pressure in the air tank from
rising above the maximum allowed value. The drain valve (7) drains condensate from the air tank.
Compressed, oil-free filtered air is stored in the air tank ready for use.
Condensate must be drained from the air tank at regular intervals (see Chapter 19.1).
Compressor with membrane dryer (Fig. 2)
The air pump (1) draws in atmospheric air through an inlet filter (8) and compresses it, feeding it
through the coolers (14) and the filter (15) into the dryer (9) and the dry, clean air is then fed through
the non-return valve (3) into the air tank (2). A part of the air is released from the dryer with the
captured moisture, which is manifested as a light air stream along the body of the dryer (9).
Condensate from the filter is automatically drained at regular intervals into the collecting bottle via
the condensate drain solenoid valve (16). The dryer ensures continuous drying of the compressed
05/2019
Level of filtration
(µm)
5
5+ 0.3
5+ 0.3
5+ 0.3 + 0.01
5+ 0.3 + 0.01
0.3 + 0.01
0.3 + 0.01
Level of filtration
(µm)
5
- 13 -
Pressure regulator
yes
no
yes
no
yes
no
yes
Pressure
regulator
no 450001011-001
yes 450001011-002
Kit article no.
447000001-043
447000001-044
447000001-071
447000001-045
447000001-072
447000001-075
447000001-076
Kit article no.
NP-DK50-10-7_05-2019-MD