Stertil koni ST 1082-E Bedienungsanleitung Seite 67

Table 7.6 Column lifts at unequal height
Cause
Control system not working correctly.
Table 7.7 Control LEDs flash or blink
Cause
The LEDs blink (0.5 sec on, 0.5 sec off).
Height difference exceeds the lowering or raising limits.
The LEDs flash (0.2 sec on, 0.8 sec off).
Error message.
The control LEDs flash in sequence.
1 (one) phase has dropped.
Table 7.8 No mains power - selection LEDs do not light up
Cause
No mains power.
Mains fuse has blown.
The mains switch is OFF.
Defective LEDs.
The control panel connector is not mounted correctly.
Table 7.9 Pushbutton indicator (LED) not functioning
Cause
The LED in the button does not light up when pressing
<UP>, <DOWN> and <Lower in the safety lock>. Lifting
system functioning normally.
Defective LEDs.
Operating instructions (Version 0)
Solution
Contact technical service.
Use the PCB keys inside the control box.
Press MS (to bypass the main relay) together with UP
to raise the lifting system, and MS together with DWN to
lower the lifting system.
w
Solution
See §
Contact technical service.
See §
Check fuses.
Phase sequence error in a new installation; reverse the
two phases on the mains switch and re-start.
Solution
Have the fault corrected by a qualified electrician.
Replace the defective fuse.
Set the mains switch to ON.
Contact the technical service.
Check the connection.
Solution
Have the LEDs replaced by the technical service.
Note
n
In the event of malfunctions other than those described here, always
consult the technical service.
66
Warning
The lifting system will then try to set itself
horizontal, bypassing all safety features. Take
care when pressing MS and DWN (lower) that
the pawls are retracted; in this case it is safer to
first raise about 30 mm with MS and UP.
7.2.1 on page 60.
7.2.2 on page 60.
Mobile column lifts ST 1082