Cleaning And Maintenance; Service Centre - Power Craft 62000 Gebrauchsanweisung

Start with coarse sandpaper and switch
to � ner paper if/when required. If a very
smooth surface is required, clean the item
thoroughly with a soft cloth after the � nal
sanding. Switch to very � ne sandpaper and
give the item one extra sanding.
Avoid blocking the ventilation slots (2) with
your hand, as this may cause the sander to
overheat.
Switch off by releasing the on/off button.

Cleaning and maintenance

GB
Wipe using a well-wrung cloth after use,
and always keep the surface and ventilation
holes free of dirt.
Always ensure the extraction holes on the
sanding pad are kept clean. Empty the dust
bag when required and never let it become
over-full.
Never use corrosive or abrasive cleaning
agents, as they may attack the plastic parts.
If the motor generates an excessive amount
of sparks, check and if necessary replace the
carbon brushes.
20

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• Open weekdays from 07.00 to 17.00
(Fridays until 15.30)
• E-mail: service@hpschou.com