NEC NP-02HD Installationsanleitung Seite 30

Installation of the light module
(3) Slide the light module forward.
When this is done, the tip of the light module's light flux pipe is inserted into the light source socket of the main
unit.
Light source socket
4 Fine-adjust the light module's mounting position.
(1) Insert the two dedicated positioning bars into the light module (see the figure).
If they enter up to the base, there is no need for the adjustment.
If the dedicated positioning bars do not fit into the bracket, move the light module a little and find the position at
which they can be inserted.
NOTE
To avoid bending the dedicated positioning bars, do not shake the light module left and right when lining
up the bars with the holes.
Dedicated positioning bar
Light flux pipe of light module
Positioning bracket
Light module
30
Light flux pipe
If the dedicated positioning bars do not fit into the bracket,
the alignment of positions is not correct.
[Cross-section image view]
Projector
[Top image view]
If the dedicated positioning bars insert
into the bracket smoothly,
the alignment of positions is correct.