NEC NP-02HD Installationsanleitung Seite 115

1-3. Project a test pattern.
(1) Turn on the power of the projector and the light
source and warm up for about 30 minutes.
Refer to page 106
the power.
(2) Operate the adjustment menu to set the Native
Color mode.
(3) Display the "MCG CG-TEST(2K)" test pattern.
Refer to "4-2-2. Test Pattern" on page 122.
2 Make the CG adjustments.
(1) Turn the G1/G2/G3 and B1/B2/B3 rubber seals
respectively to reveal the adjustment windows.
* B2 is L-shaped. The adjustment window is
underneath.
Rubber seal
(2) Use the ballpoint drivers to adjust by turning the
adjustment screws clockwise or counterclock-
wise.
• For example, to adjust Green, it is easier to
adjust from the right side by inserting the
three ballpoint drivers into the G1, G2 and
G3 adjustment screws beforehand.
• The positions and directions of the adjust-
ment screws differ, as shown in the figures
below.
Locations and directions of the G1/G2/G3 and B1/B2/B3 adjustment screws
for instructions on turning on
Adjustment window
Projector Adjustment and Connecting
G1
B1
Lens direction
G2 G3
B2
B3
115