2.9
Maintenance tasks
2.10
Operating fluid
2.11
Operator responsibilities
3
Application/use
3.1
Intended use
Installation and operating instructions Wilo-EMU KS
Application/use
▪ Under normal operating conditions, the sound pressure level of the device is below
85 dB(A). However, the actual sound-pressure level depends on several factors:
– Installation depth
– Installation
– Fixation of accessories and pipe
– Duty point
– Immersion depth
▪ If the device is operated under normal operating conditions, the operator must measure
the sound pressure. Ear protection must be worn for sound pressure levels of 85 dB(A)
and above and this must be noted in the work regulations!
▪ Wear the following protective equipment:
– Closed safety goggles
– Safety shoes
– Safety gloves for protection against cuts
▪ Always carry out maintenance tasks outside the operating space/installation site.
▪ Only carry out maintenance tasks mentioned in these installation and operating in-
structions.
▪ Only original parts from the manufacturer may be used for maintenance and repairs.
Use of parts other than the original parts releases the manufacturer from any liability.
▪ Collect any leakage of fluid and operating fluid immediately and dispose of it according
to the locally applicable guidelines.
▪ Store tools at the designated locations.
▪ After completing work, reattach all safety and monitoring devices and check that they
function properly.
Changing operating fluid
In case of a defect, a pressure of several bar can build up in the motor! This pressure
escapes when the screw plugs are opened. If screw plugs are opened without due cau-
tion, they can be ejected at high speed! To avoid injuries, observe the following instruc-
tions:
▪ Adhere to the prescribed sequence of work steps.
▪ Unscrew the screw plugs slowly, but never unscrew them completely. As soon as the
pressure escapes (audible whistling or hissing of air), stop turning the screw plug any
further.
WARNING! Hot operating fluids can also spray out when the pressure is escaping.
This can result in scalding! To avoid injuries, allow the motor to cool down to the
ambient temperature before carrying out any work!
▪ When the pressure has completely dissipated, fully unscrew the screw plug.
Motor in the motor compartment and the sealing chamber is filled with white oil or a
water-glycol mixture. Operating fluids must be replaced during regular maintenance
work and disposed of according to the local guidelines.
▪ Installation and operating instructions must be in a language which the personnel can
understand.
▪ Make sure that the personnel is relevantly trained for the specified work.
▪ Provide the necessary protective equipment and make sure that the personnel wears it.
▪ Safety and information signs mounted on the device must be always legible.
▪ Train the personnel pertaining to the functioning of the system.
▪ Eliminate risk from electrical current.
▪ Equip hazardous components inside the system with an on-site guard.
▪ Identify and cordon off the work area.
▪ To ensure safe working practice, define the responsibilities of the employees.
Children and persons younger than 16 years or with reduced physical, sensory or mental
capacities or limited experience are prohibited from handling the product! A technician
must supervise persons younger than 18 years!
Submersible pumps are suitable for pumping:
▪ Wastewater
▪ Fluids containing abrasive content (e.g. sand, gravel).
en
215