After Use; Cleaning And Maintenance - Meister MAS12VL Originalbetriebsanleitung

MW-5450680-Bediene-1711 23.11.17 13:50 Seite 73
CAUTION! Risk of over winding
caused by screwing screws in
too deep. Watch the screwing
process carefully and, if necessary,
stop early and finish the process
with an ordinary screwdriver. Carry
out test installations!
Gear switch (Figure 7)
Using the gear switch (3) you may
select two different revolution ranges.
• Switch position 1:
-1
0 – 400 min
removing screws
• Switch position 2:
-1
0 – 1500 min
screws and drilling
The revolution range to be selected
is determined by the relevant
material and the intended task and
should be tested using a test piece.
CAUTION! Only switch over
when the motor is at a
standstill.
11 – After use
• Release the On/Off switch to
switch the machine off.
• Set the left/right rotation to the
middle position to block the On/Off
switch and prevent unintentional
activation of the machine.
• Remove the rechargeable battery
and the tool before you clean and
store the machine.
for installing and
for installing
• Clean the machine as described
under "Cleaning and maintenance".
12 – Cleaning and
maintenance
Cleaning
CAUTION! Electric shock!
WARNING! Risk of electric
shock!
• Wait until the machine has
cooled down and remove the
rechargeable battery from the
machine.
• Before cleaning the charger,
always pull the plug out.
• Make sure that no water is able to
enter the machine.
• Do not damage the surfaces of
the machine.
• Do not use aggressive cleaning
agents, brushes with metal or
nylon bristles, or sharp or metallic
cleaning tools such as knives,
hard spatulas or similar.
• Use a mild cleaning agent and a
dry or damp, but not dripping
wet, cloth. Do not use cleaning
agents that contain solvents!
• Always keep the ventilation slots
free from dust deposits in order to
prevent the machine from
overheating.
73