Meister MAS36VL Originalbetriebsanleitung Seite 59

5450020-Akku-Schra_man 23.02.18 14:12 Seite 59
Hand/arm vibrations
Driving screws a
Measuring inaccuracy K: 1,5 m/s
Noise and vibration information
The listed sound and vibration values have been determined in accordance
with the norms EN 60745-1 and EN 60745-2-2.
The specified vibration emission value was measured in accordance with a
normed test procedure and can be used in order to compare one electrical
tool with another.
The specified vibration emission value can also be used for an introductory
evaluation of the influence.
CAUTION! Risk of injury due to vibrations! The vibration emission
value may fluctuate from the specified value during use of the
power tool. These fluctuations will depend on the way in which the
power tool is used.
– Specify safety measures to protect the operator. As a result, the evaluation
of the influence must be made whilst taking account of the actual
conditions of use. (All parts of the operating cycle must be taken into
account for this purpose. This also includes times in which the power tool
is switched off and times in which it is switched on, but is running without
load.)
CAUTION! Damage to hearing! The effects of noise may cause
damage to your hearing.
– Only work with suitable ear defenders.
– Anybody else in the vicinity must also wear suitable ear defenders.
CAUTION! Noise disturbance! A certain amount of noise is
unavoidable when using this machine.
– Ensure you carry out noise-intensive work during permitted times.
– Maintain the quiet periods and limit your working time to the absolute
minimum.
2
: ≤ 2.5 (0.195) m/s
h
2
59