Piezotome Function - Satelec ACTEON Implant Center 2 Benutzerhandbuch

e) Torque adjustment
On the main screen, press button
torque adjustment screen is displayed (Fig. 7).
Program the torque using the numeric keypad (Fig. 7-
31).
The programmed torque is displayed (Fig. 7-27).
Press button (Fig. 7-29) to delete the last digit.
Press button (Fig. 7-28) to return to the main
screen without saving the changes.
Confirm the torque adjustment by pressing button
(Fig. 7-30); the main screen is displayed.
Note: The instrument torque can be adjusted directly
using buttons or
program , even when the multifunction
footswitch is switched on.
f) Selecting footswitch type
Change the footswitch type if necessary by pressing
button (Fig. 3-10) to toggle between ON/OFF
and progressive
g) Light
If necessary, select light function ON/OFF by pressing
button (Fig. 3-11).
h) Completion of setting adjustment
Confirm the new settings by pressing button
3-8).
The storing of the various settings is confirmed by an
audible signal.
Repeat this sequence if necessary in order to adjust
all the programs.
14
(Fig. 6-22); the
(Fig. 3-6 and 3-7) for
.

7. 6 PIEZOTOME FUNCTION

Important:
The P
IEZOTOME
by the user.
The P
IEZOTOME
when no P
IEZOTOME
device.
The program giving the highest power is D1.
Very powerful
Powerful
Medium
Low
Select the Piezotome function by pressing button
(Fig. 3-12) or by pressing the footswitch
button (Fig. 11-5).
On the LCD screen, the P
highlighted.
Select the program to be used by pressing button
,
the footswitch button (Fig. 11-3); the selected
program is highlighted on the LCD screen.
Adjust the programs and the power level according to
the tip data sheet recommendations.
If necessary, modify the irrigation function (flow rate
value, etc.) (refer to 7.3).
If necessary, modify the program power level (1 to 5)
using buttons
(Fig. The power level of the program concerned is shown
as a number and a bar-graph
Modify the footswitch type if necessary by pressing
button (Fig. 3-10) to toggle between ON/OFF
function settings can be customized
function settings can be adjusted
2 handpiece is connected to the
Program Main functions
D1
D2 Osteotomy, osteoplasty
D3
D4 Soft tissue detachment
IEZOTOME
, or (Fig. 4-14) or using
(Fig. 3-6) and (Fig. 3-7).
tab must be
(Fig. 4-13).