Unpacking - Ryobi RBL42BP Bedienungsanleitung

8. Bellows tube
9. Nozzle
10. Primer bulb
ASSEMBLY

UNPACKING

The product requires assembly.
■ Carefully remove the product and any accessories
from the box. Make sure that all items listed on the
packing list are included.
WARNING
Do not use the product if any parts on the packing list
are already assembled when you fi rst open the box.
The parts on the packing list are not assembled by the
manufacturer and require customer installation. Use of
a product that may have been improperly assembled
could result in serious personal injury.
■ Carefully inspect the product to make sure no
breakage or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, please call your
Ryobi service centre for assistance.
PACKING LIST
■ Backpack blower
■ Upper tube
■ Bellows tube
■ Lower tube
■ Nozzle
■ Locking clamps
■ Adjustable harness and waist straps
■ Bottle of 2-cycle engine lubricant
■ Operator's manual
■ Figure sheet
NOTE: Read and remove all hang tags and store with your
operator's manual.
WARNING
If any parts are damaged or missing, do not operate the
product until the parts are replaced. Use of the product
with damaged or missing parts could result in serious
personal injury.
English (Original instructions)
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
ASSEMBLING AND DISASSEMBLING THE UPPER
TUBE AND BELLOWS TUBE
See Fig. 2.
1. Attach the bellows tube to the main housing outlet and
2. Attach the upper tube to the bellows tube. Secure the
3. To disassemble, loosen the locking clamps using a
ASSEMBLING AND DISASSEMBLING THE LOWER
TUBES AND NOZZLE
See Fig. 2.
1. Align the raised locking tabs on the lower tube to the
2. Secure the nozzle and lower tube together by aligning
3. To disassemble, raise the locking tab with a fl at head
ADJUSTING THE HARNESS AND WAIST STRAPS
Make all adjustments to the harness straps before
starting the blower to avoid the possibility of injury.
To adjust harness strap assembly:
■ The blower should be in operating position before
■ There are two possible height adjustment positions
17
WARNING
WARNING
secure with a locking clamp.
upper tube in place using the locker clamp.
hex wrench. Pull the upper tube and bellows tube from
the main housing.
slots on the upper tube. Slide together and tighten
securely by twisting.
the raised locking tab on the lower tube with the raised
slot on the nozzle.
screwdriver, rotate the tube and nozzle to unlock and
remove from the main housing outlet.
CAUTION
adjusting the harness straps. Slip your arm through
the harness strap and onto your shoulder, then repeat
for the other shoulder.
that can be used to easily adjust the harness.