Replacing The Lamp; Troubleshooting - JUNO JB131D8 Benutzerinformation

4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
6. Pull the door trim to the front to
remove it.
7. Hold the door glass panels by their top
edge and carefully pull them out one
by one. Start from the top panel. Make
sure the glass slides out of the
supports completely.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
Do not clean the glass panels in the
dishwasher.
When the cleaning is completed, install
the glass panels and the oven door.
Make sure that you put the glass panels
(A and B) back in the correct sequence.
Check for the symbol / printing on the side
of the glass panel, each of the glass
panels looks different to make the
disassembly and assembly easier.
When installed correctly the door trim
clicks.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
1
A B
Make sure that you install the middle
panel of glass in the seats correctly.

Replacing the lamp

WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
CAUTION! Always hold the
halogen lamp with a cloth to
prevent grease residue from
burning on the lamp.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
31
A
B