Replacing The Lamp; Troubleshooting - JUNO JB094C9 Benutzerinformation

26

Replacing the lamp

WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
CAUTION! Always hold the
halogen lamp with a cloth to
prevent grease residue from
burning on the lamp.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
There is no good cooking
performance using the func‐
tion: True Fan Cooking
PLUS.
There is no good cooking
performance using the func‐
tion: True Fan Cooking
PLUS.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
You did not turn on the func‐
tion: True Fan Cooking
PLUS.
You did not fill the cavity
embossment with water.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Activating the func‐
tion: True Fan Cooking
PLUS".
Refer to "Activating the func‐
tion: True Fan Cooking
PLUS".