Setting The Duration - JUNO JB131D8 Benutzerinformation

Clock function
00:00 COUNT UP TIMER
Setting and changing the time
After the first connection to the mains, wait
until the display shows
flashes.
1. Touch or
2. Touch or
3. Touch or
4. Touch or
The display shows the new time.
To change the time of day touch
and again until

Setting the DURATION

1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Use or to set the minutes for
DURATION time.
4. Press or the DURATION time
starts automatically after 5 seconds.
5. Use or to set the hours for
DURATION time.
6. Press . The DURATION time starts
automatically after 5 seconds.
When the set time ends, the signal sounds
for 2 minutes. and time setting flash in
the display. The oven turns off.
7. Press a sensor field to stop the signal.
8. Turn off the oven.
Setting the END
1. Set an oven function and temperature.
2. Touch again and again until
starts to flash.
Application
To set the count up, which shows how long the oven
works. This function has no effect on the operation of the
oven. It is on immediately when the oven starts to heat.
The COUNT UP TIMER is not turned on if DURATION and
END are set.
and 12:00. "12"
to set the hours.
.
to set the minutes.
.
again
starts to flash.
3. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic
signal sounds for 2 minutes.
time setting flash in the display. The
appliance deactivates automatically.
4. Touch a sensor field to stop the
acoustic signal.
5. Turn off the appliance.
Setting the TIME DELAY
function
1. Set an oven function and temperature.
2. Touch again and again until
starts to flash.
3. Use or to set the minutes for
DURATION.
4. Touch .
5. Use or to set the hours for
DURATION.
6. Touch , the appliance switches to
the setting of the END function.
The display shows flashing
7. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
Appliance turns on automatically later on,
works for the set DURATION time and
stops at the set END time. At the set time
an acoustic signal sounds for 2 minutes.
and the time setting flash in the
display. The appliance deactivates
automatically.
8. Touch a sensor field to stop the
acoustic signal.
9. Turn off the appliance.
11
and the
.