Selecting The Operation Mode For Automatic Printing Capabilities - Sony UP-50 Gebrauchsanweisung

Setting Up the Printer (Continued)
Selecting the Operation Mode for Automatic Printing
Capabilities
104
Installation and Adjustment
You can control the printer using either of the following remote control units
connected to the REMOTE 2 or REMOTE 3 connector on the rear panel of the
printer.
• RM-91 Remote control unit (not supplied): Connected to the REMOTE 2
connector
• FS-30 Foot switch (not supplied): Connected to the REMOTE 3 connector.
In addition, you can also remote control the printer by using a remote control unit
which sends the remote control signal to the Pin No.5 of the REMOTE 3
connector.
Using the menu, you can assign the desired functions to the remote control unit
connected to the REMOTE 2 or REMOTE 3 connector.
In addition, the printer can be remotely controlled by a pulse signal input to
REMOTE 2 or REMOTE 3. (See pages 126 and 127).
Also, you can control the printer using a personal computer.
For detailed information on controlling with the computer, contact with your Sony
dealer.
Note
The FS-36 foot switch is connected to REMOTE 2 to control the printer. However,
the function of this foot switch cannot be assigned using the menu.
1
Press the MENU button, then select PRN by pressing the G or g button.
The PRINTER SETUP menu appears on the source image.
PRINTER SETUP COLOR : 200
/ COL / LAY / PRN / IN / OUT /
PRINT QTY. : 1 [ 1 ~ 9 ]
INTERVAL : OFF / ON
GAMMA : S / NORMAL / H
PRN SPEED : / HIGH
MOTION CHK : OFF / ON
LOAD USER : 1 / 2 / 3 [ EXEC ]
SYSTEM : PRESS [ > ]
FUNCTION : PRESS [ > ]
C - BALANCE : PRESS [ > ]
Q1 A 1
Switch PRN to green by
pressing the G or g button.
2,4,6
1,7
3
5,6
P R I NT ER S E T UP
/ c / l / PRN / i / o /
Display PRN in capital letters by
S
pressing the G or g button.