Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Type
No.
M1
M2
M3
M4
M5
M6
MA
MB
MC
FM
AC
AM
RP
MP
R+
R-
S+
S-
IG
*1. The default settings are given for terminals S3 to S7. For a 3-wire sequence, the default settings are a 3-wire sequence for S5, multi-
step speed setting
1 for S6 and multi-step speed setting 2 for S7.
*2. Do not use this power supply for supplying any external equipment.
*3. When driving a reactive load, such as a relay coil with DC power supply, always insert a flywheel diode as shown in
*4. Pulse input specifications are given in the following table:
Low level voltage
High level voltage
H duty
Pulse frequency
IMPORTANT
EN-10
Signal Name
During run (NO)
Zero speed (NO)
Speed agreement detection
(NO)
Fault output signal
Output frequency
Analog common
Inverter output power
Pulse Input
Pulse Output
MEMOBUS communications
input
MEMOBUS communications
output
Signal common
0.0 to 0.8 V
3.5 to 13.2 V
30% to 70%
0 to 32 kHz
Coil
External power:
30 VDC max.
Fig 6 Flywheel Diode Connection
1. In
Fig 4
the wiring of the digital inputs S1 to S7 is shown for the connection of contacts or NPN transis-
tors (0V common and sinking mode). This is the default setting.
For the connection of PNP transistors or for using a 24V external power supply, refer to
2. A DC reactor is an option only for Inverters of 18.5 kW or less. Remove the short circuit bar when con-
necting a DC reactor.
Function
Closed during Run
Closed when output
Function
frequency at zero level
selected by
(b2-01) or below
H2-01 to H2-03
Within ± 2 Hz of set fre-
quency when ON
Closed across MA and MC during faults
Open across MB and MC during faults
Analog output fre-
Function
quency signal;
selected by
0 to 10 V; 10V=FMAX
H4-01
–
Analog output power
Function
signal;
selected by
0 to 10V; 10V=max.
H4-04
appl. motor capacity
H6-01 (Frequency reference input)
H6-06 (Output frequency)
For 2-wire RS-485, short R+ and S+
as well as R- and S-.
–
Flywheel diode
1 A max.
Signal Level
Relay contacts
Contact capacity:
1 A max. at 250 VAC
1 A max. at 30 VDC
0 to +10 V max. ±5%
2 mA max.
–10 to +10 V max. ±5%
2 mA max
4 to 20 mA
0 to 32 kHz (3kΩ)
*4
High level voltage 3.5 to
13.2 V
0 to 32 kHz
+15 V output (2.2kΩ)
Differential input,
PHC isolation
Differential input,
PHC isolation
–
Fig 6
The rating of the flywheel diode must
be at least as high as the circuit volt-
age.
Table
3.
*3
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
