Configuring Alarm Loops - Renkforce 751514 Bedienungsanleitung

10.6 Configuring alarm loops

You can be freely programme individual loops to suit your requirements.
The following example is related to the preset programming (factory setting).
Memory
location
(press the displayed digits
on the control panel)
Loop 1 21
Loop 2 22
Loop 3 23
Loop 4 24
Loop 5
25
Loop 6
26
Loop 7
27
Loop 8
28
Brief overview
Code 1: Response characteristic
Code 2: Activation characteristic
Code 3: Response time
Code description
Code 1: Response characteristic
Possible parameters are 0 or 1
0 = single alarm activation
The loop only triggers once. It cannot process a second alarm detection. This function should be selected if
no second acoustic alarm signal (siren) is to be sounded. Arming / disarming the alarm control centre also
makes the thus programmed zone active again.
1 = multiple alarm activation (factory setting)
The loop can be triggered several times. If the alarm control centre has sounded an alarm, clamp 8 (e.g.
siren) will be activated for the programmed time. Once this time is passed, the loop is active again and can
produce further alarm signals at clamp 8.
112
Code 1 Code 2
(enter the desired (enter the desired
user code on the user code on the
control panel) control panel)
1 1
1 1
1 0
1 0
1 0
1 0
1 3
1 3
Code 3 Confirmation
(enter the desired (press the displayed
user code on the button on the control
control panel) panel)
2 #
2 #
2 #
2 #
2 #
2 #
2 #
2 #