Exit Programming Mode; Programming Mode, Forgotten Master Code; Changing Master Code - Renkforce 751514 Bedienungsanleitung

10.2 Exit programming mode

Proceed as follows to leave the programming mode:
*
• To leave the programming mode press the " " button twice.
You should not be in a parameter input menu when you exit.
• The control panel confirms the input with two signal tones.
• The LED "PROGRAM" is no longer lit.

10.3 Programming mode, forgotten master code

If the original master code (factory setting 1234) has been changed and you can no longer remember it, you
need to carry out the following procedure to re-enter the programming mode.
• Remove the alarm control centre from the mains power supply and disconnect the battery.
• Move the jumper DAP from OFF to ON.
• Connect the alarm control centre to the mains supply again. The control panel emits a permanent signal
tone.
• Move the jumper DAP back to the OFF position. The LED "PROGRAM" lights up.
• The alarm control centre is now in programming mode and you can enter your new master code.

10.4 Changing master code

The alarm control centre should now be in programming mode (see Chapter "10.1 Start Programming
Mode").
Please proceed as follows to change the master code:
• Enter the memory location 01 by pressing the 0 button and then the 1 button.
• Enter your desired master code via the control panel (must be between 2 and 5 digits).
• Save your input with the "#" button.
• The old master code will now be overwritten. Only use the new master code from now on.
110