Herunterladen Inhalt Inhalt Diese Seite drucken

Flame Baffle Plate; Adjusting The Door / Replacing Door Seal; Supplementary Installation Instructions Per Appliance; Jannik Medium Low Ea - Dik Geurts Jannik Medium LowEA Installationsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9.3.2 Flame baffle plate

On delivery the flame baffle plate (see Appendix 2, fig. 5) is located in the top section of the appliance.
In case of maintenance to the appliance, the flame baffle plate has to be removed.
To do this proceed as follows:
Ø
Take hold of the flame baffle plate and push the right side upwards.
Ø
Slide the flame baffle plate over the ridge to the right.
Ø
Lower the left side of the flame baffle plate and remove the flame baffle plate.
Placing the flame baffle plate takes place in reverse order.
The stainless steel profile must be placed at the front with the screw heads facing the top (see Appendix 2, fig. 5).
!Caution

9.4 Adjusting the door / Replacing door seal

Check the closing of the door during installation or maintenance.
To do this proceed as follows:
Ø
Check the sealing of the door by placing a sheet of paper between the door and the fire. After closing the door, it
should not be possible to pull out the sheet of paper easily. Check the outside of the fire.
If there is insufficient connection (gaps), the door can be adjusted in case of the Jannik Medium Low
see paragraph 9.5. The door seal can be replaced at all appliances described in this manual. For this, we would also
like to refer you to paragraph 9.5.

9.5 Supplementary installation instructions per appliance

9.5.1 Jannik Medium Low

9.5.1.1 Outside air connection

The fire is made with an outside air connection. This outside air connection is supplied separately.
Assembly always takes place at the bottom of the appliance.
When mounting the outside air connection, please proceed as follows (see Appendix 2, fig. 6):
Ø
Loosen the 5 bolts that are pre-mounted on the outside air connection.
Ø
Bring the outside air connection against the plate on the bottom of the appliance.
Ø
Then re-tighten the 5 bolts.
Ø
Connect the flexible hose to the round 'pipe opening' of the above-mentioned tray.
The flexible hose can only be fed from the rear.
9.5.1.2 Adjusting the door / Replacing door seal
At delivery and during maintenance you should check the play in the door and how the door closes.
In case of a door that does not open and close smoothly, there are a number of measures that you can take. For
instance:
You can adjust the door by slightly moving the door catches (see Appendix 2, fig. 7).
To do this proceed as follows:
Ø
Loosen the nuts a little.
Ø
Adjust the door catches.
Ø
Then re-tighten the nuts properly.
Ø
Check whether the sealing tape makes a good connection by clamping a sheet of paper between the fire and the
sealing tape when closing the door.
Ø
It should not be easy to pull out the sheet of paper. If necessary, adjust the door and/or replace the door seal (=
sealing tape).
UK
EA
apply a little bit of heat resistant grease on the shaft of the seal;
adjust the door;
replace the door seal.
IN S TA L L A TI O N M A N U A L
EA
. For this,

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis