Adjusting The Waiting Period Of The Screensaver - G&D DP-Vision-CAT Installation Und Bedienung

Configuration

Adjusting the waiting period of the screensaver

The screensaver turns off the display of the console after the user has been inactive
for a defined period of time.
NOTE:
This setting does not affect the screensaver settings of the computer con-
nected to the computer module.
How to adjust the waiting period of the screensaver:
1. Press Ctrl+Num
2. Select the row
saver of the remote console (at the
Select the row
screensaver of the local console (at the
3. Under Screensaver (min)
screensaver.
Entering the value 0 disables the screensaver.
4. Press F2 to save your settings.
1. Click on
KVM Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tab
sole (at the
Click on the tabs
the remote console (at the
4. Under
Screensaver (minutes)
screensaver.
Entering the value 0 disables the screensaver.
5. Click to save your changes.
OK
40 · G&D DP-Vision-CAT
(default) to open the on-screen display.
Console setup and press
Local console setup
enter a waiting period (1 to 999 minutes) for the
if you want to adjust the screensaver of the local con-
Local
module).
CPU
Remote > General
CON
enter a waiting period (1 to 999 minutes) for the
Enter if you want to adjust the screen-
CON module).
and press Enter if you want to adjust the
CPU module).
on the directory tree.
if you want to adjust the screensaver of
module).