Evolution FURY6 Originalbetriebsanleitung Seite 29

www.evolutionpowertools.com
To change a blade:
• Ensure that the machine is in Mitre Saw Mode with the
Cutting Head in its upper position.
• Release the Retractable Lower Guard Operating Lever by
removing and safely storing its pivot screw. (Fig. 28)
• Use the pin spanner (provided) to hold the outer blade flange.
• Use the hex key (provided) to unscrew the arbor screw. (Fig. 29)
Note: The arbor screw has a Left Hand thread. Turn clockwise to
undo and counterclockwise to tighten.
• Remove the arbor screw, washer and outer blade flange.
• Manually operate the Lower Blade Guard and retract it fully
up into the body of the machine
• Remove the blade by withdrawing it outwards to clear the
end of the arbor and then downwards and forwards away
from the machine.
Note: The 5mm blade slot at the lower front of the Cutting
Head (Fig. 30) provides extra clearance when manoeuvring the
blade into or out of the machine.
To refit:
• Ensure that the blade is suitable for this machine.
• Ensure that the direction of rotation arrow on the blade
matches the direction of rotation arrow found on the
machines Side Blade Guard. The blade teeth should always
point downward at the front of the saw.
• Using the blade slot to provide maximum clearance and access
to the machine, carefully and gently manoeuvre the blade up
into the machine and locate it on the inner blade flange.
• Reinstall the outer blade flange, washer and arbor screw.
• Hand tighten the assembly.
• Hold the outer blade flange with the pin spanner.
• Tighten the arbor screw with the hex key.
• Check that the blade spins freely by rotating it by hand.
• Close the Retractable Blade Guard around the blade so the
blade teeth are completely covered.
• Re-connect the Retractable Blade Guard Operating Lever to
its service position using the pivot screw.
• Check the installation, particularly for the operation of all the
safety guards.
Fig. 28
Fig. 29
Fig. 30
29
EN
DE
FR
TR