Evolution FURY6 Originalbetriebsanleitung Seite 18

Fig. 3a
Fig. 3b
(Dust bag, not supplied)
Fig. 4
Fig. 5
To fit the Stabilising Arms:
• Remove the cross head machine screws from the two (2) rear
mounting positions.
• Attach the Stabilising Arms with the machine screws, two per
arm and tighten securely.
Note: The Stabilising Arms are fitted with rubber feet. The base
of the Fury6 is also fitted with four (4) identical rubber feet
positioned underneath the mounting holes in the base.
When used as a portable machine the six (6) rubber feet provide
the security and stability necessary for safe operation.
Note: When the machine is re-positioned the operator should
ensure that none of the rubber feet become detached from the
machine. The rubber feet can, in some circumstances, stick to
some surfaces due to vacuum suction.
If any of the rubber feet become detached or damaged they
must be replaced.
DUST BAG
A Dust Bag (not supplied) can be fitted to the extraction port at
the rear of the machine. (Fig. 3a & 3b)
• Push the adaptor tube into the extraction port at the rear of
the machine.
• Slide the Dust Bag onto the adaptor tube ensuring that the
spring clip grips the tube holding the Dust Bag securely in place.
Note: For operational efficiency empty the Dust Bag when it
becomes 2/3 full. Dispose of the contents of the Dust Bag in an
environmentally responsible way. It may be necessary to wear a
dust mask when emptying the Dust Bag
WARNING: DO NOT USE A DUST BAG WHEN CUTTING STEEL.
18
www.evolutionpowertools.com