Evolution FURY6 Originalbetriebsanleitung Seite 25

www.evolutionpowertools.com
FENCE ASSEMBLY (Fig. 19)
The Fence Assembly consists of two (2) main parts:
• The Angle Gauge.
• The Rip Fence Face Plate.
Note: The 'T' slot in the Rip Fence Face Plate is not centrally located.
• Slide the Rip Fence Face Plate onto the two (2) mounting
screws found on the Angle Plate.
• Ensure that the wider (20mm) portion of the Fence Face is
downwards and will lie on the saw table when in use.
The Angle Plate can now be slid into the Rip Fence channel
found at the front of the machine table. (Fig. 20)
Slide in from the Right Hand side ensuring that the Locking Clamp
engages correctly with the front face of the Rip Fence channel.
FENCE ASSEMBLY AS A RIP FENCE
To use the Fence Assembly as a Rip Fence the Face Plate must
be accurately aligned with the blade.
WARNING: Only carry out this procedure with the machine
disconnected from the power supply.
To Align the Rip Fence:
• Ensure that the table is at its lowest setting (see Fig. 23a &23b)
• Set the Angle Gauge to an indicated 90˚.
• Slide the Fence Assembly up to the blade, raising the Blade
Guard by hand so that the Face Plate rests alongside the
blade and underneath the Blade Guard. (Fig.21)
• Gently tighten the Angle Gauge Locking Clamp Screw to lock
the Assembly into the Rip Fence channel.
• Check that the Face Plate is in exact alignment with the blade.
• If adjustment is required, loosen slightly the Angle
Clamping Screw and adjust the Angle Gauge until exact
alignment is achieved.
• Tighten the Angle Clamping Screw.
• Adjust the Angle Gauge Pointer if necessary to point exactly
to the 90˚ index mark.
• Use a #2 Phillips Head screwdriver to loosen the Angle
Pointer fixing screw. (Fig. 22) Adjust the pointer to suit and
then retighten the fixing screw.
• Loosen the Angle Clamp Locking Screw to allow the
Assembly to slide along the Rip Fence channel.
Fig. 19
Fig. 20
Fig. 21
Fig. 22
25
EN
height
DE
FR
TR