Emmaljunga Twin Cerox 360 Gebrauchsanweisung Seite 33

Care and maintenance
Washing instructions
• Hood: Take off and extend the hood. Shower the hood from the inside (interior fabric) with luke warm water.
Use mild liquid soap as detergent. Cleanse it thoroughly. Drip dry the fully extended hood.
• Seat fabric and 5-point harness (only applies to City Cerox 360 and Twin City Cerox 360): Remove the seat
fabric from the chassis. Remove the seat-board; store it in a dry place. Hand wash seat fabrics in lukewarm
water. Use mild liquid soap as detergent. Cleanse thoroughly. Drip dry the seat fabric. When the seat fabric is
removed the 5-point harness is accessible. Only wipe the nylon straps and plastic parts clean with a damp-
cloth. Do not hand wash. Make sure the harness is dry before reassembly.
• Front bar padding (only applies to City Cerox 360 and Twin City Cerox 360): Remove the front bar padding/
apron. Hand wash in luke warm water. Use mild liquid soap as detergent on the surface of the exterior fabric.
Handle non-woven interior material with care. Drip-dry.
• Pram body (City Carry-cot):
Wipe the exterior fabric and the interior lining material, clean with a damp cloth. Do not hand wash. Use
a mild liquid soap as a detergent. Drip dry. Dry the pram body in its fully extended position. Make sure the
wooden base is protected from any water.
General Information
• Ironing: If any fabric part needs to be ironed, always use a 100 % cotton cloth in-between the iron and the
fabric to protect the fabric surface. Iron the exterior fabrics (100 %) polyester and the interior fabrics on
gentle heat (110°C on the iron).
• Make sure all parts are completely dry before reassembly. Check the trimmings and the seam on the seat
fabric underneath the backrest-pocket.
• You may apply a material protector (like Scotchgard™) on the exterior fabric after washing. Always apply
before reassembly.
WARNING
• Do not place child/children in stroller for at least 24 hours after applying a material protector.
Reassembly after washing
WARNING
• Make sure all parts are assembled correctly according to the instructions in this manual.
• Make sure the seat-board and the foot-rest-board are correctly positioned before reassembly and use.
Manual City Cerox 360 v. 1.3
This section applies to all products
33