Emmaljunga Twin Cerox 360 Gebrauchsanweisung Seite 24

Assembly of seat-unit
9
10
14
13
15
11
16
12
24
Assembly of Hood
• Press the two plastic legs, one on each side of the hood, into the two
plastic holders on the seat frame, one on each side.
Make sure they snap into place.
• Press the press studs into place on both sides of the hood
• Fasten the two plastic hooks (13) on the hood apron (14), to the met-
albar (15) of the seat adjustment lever.
Twin Cerox 360: four plastic hooks
13
IMPORTANT
• The hood should always be assembled when the pram is used and
the hooks should be fastened.
Assemble the safety barrier (only Twin Cerox 360)
• Slide the safety barriers (16) lower part through the slit on the under
side of the hood pocket.
WARNING
• The plastic safety barriers (16) must always be able to move freely
through the slit on the under side of the hood.
Assembly of Apron (Accessory)
• Slip the apron over the footrest and pull toward the front of the hood.
Snap the apron onto the four press-studs, two on each side of the
hood.
IMPORTANT
• The hood can not be folded with the apron attached.
This section applies to following products:
City Cerox 360 & Twin City Cerox 360
Manual City Cerox 360 v. 1.3