2.17.1 Checking and Setting with a Dial Gauge (Precise Adjustment)
a)
7
8
c)
7
8
34
9
–
To measure the 3 different dimensions, the dial gauge 9, the
blocks 8 and the knurled nut 7 must be mounted differently for
each. The illustrations show the correct arrangement for each:
Illustration a)
Illustration b)
Illustration a)
Note:
If multiple machines are to be set to the same crimping values, then
only link 3 for the rear feed dog may still be changed slightly after the
base setting.
Setting
9
–
Adjust the left link 3 for the rear feed dog, the right link 2 for the
forward feed dog and the link 5 for the transport foot appropriately.
–
Loosen screw 4, 1 or 6 respectively
–
Insert a pin into the hole in the link and turn the link.
Direction +
Direction –
–
Tighten screw 4, 1 or 6 again.
–
Hold down the "Y" key and tap the "F" key.
The parameter menu is turned on.
–
Advance to parameter 16 (tape operation on/off) through repeated
pressing of the "Y" key.
Parameter 16 is set as follows in the various classes:
Class
550-12-23
550-12-24
550-12-26
–
Press the appropriate key.
–
Hold down the "Y" key and tap the "F" key.
The parameter menu is turned off.
b)
7
Feed dog at the rear with dial gauge
Transport foot
Feed dog forward with dial gauge
= Greater stitch length
= Smaller stitch length
Value
0
0
1
8
9