Operating The Controls; Manual Sewing; Sewing With A Program; Model Selection - Dürkopp Adler 550-12-23 Bedienungsanleitung

3.

Operating the Controls

3.1 Manual Sewing

3.2 Sewing with a Program

3.2.1 Model Selection

3.2.2 Sewing

The 550-12-23; -24; -26 are equipped with programable controls. The
functions can be programmed via the keypad.
If sewing is to take place without a program, the manual sewing mode
is to be activated using one of the following methods:
1. Method
–
Press the "P" key.
–
Enter "000".
"000" appears in the right display.
2 seconds later "00" appears in the left display.
2. Method
–
Hold the "P" key down and tap the "E" key.
"00" appears in the left display.
Programs already generated for a specific model can be called up as
follows:
–
Press the "P" key.
–
Enter the three-digit model number.
Example: model 17 is to be called up = enter "017".
2 seconds later the display shows the current crimping value at the
left, the program step in the center and the model number at the
right.
–
Sew the first part.
–
Press the hand switch.
The display shows the new crimping value at the left, the step 02
in the center and the current part number at the right.
If a small "e" appears to the right in front of the part number, this
means that the current part has been completed after the next
seam is sewn.
If a capital "E" appears to the right in front of the part number, this
means that the program is over after the next seam is sewn. Then
the model has also been sewn to completion.
–
Sew the next part.
–
Press the hand switch.
Run through the program to the end in this manner.
When the last seam has been sewn, the program starts at the be-
ginning again.
1
13