Ip.mode - Kollmorgen AKD Series Benutzerhandbuch

AKD Benutzerhandbuch | 25.25.3 IP.MODE

25.25.3 IP.MODE

General Information
Type
Description
Units
Range
Default
Value
Data Type
See Also
Start Version M_01-04-013-000
Variants Supported
AKD BASIC
AKD SynqNet
AKD EtherNet/IP
Fieldbus Information
Fieldbus Index/Subindex Is 64 bit? Attributes Signed?
Modbus 1212
Description
This command determines which method of acquiring an IP Address the drive will take.
The drive will attempt to acquire a new IP Address as soon as the IP.RESET (s: 755) command is issued.
IP Mode
0
1
2
Recovering communications with a drive on an un-reachable IP address
Sometimes a drive may be configured for an IP Address, and the drive needs to be taken off-line, and
bench tested, or otherwise used outside of its saved IP Settings. If IP.MODE has been set to 1 (using soft-
ware defined static IP), the drive will boot up on an IP Address that may be unreachable with the host com-
puter's settings.
If the IP address prevents communication the IP settings can be reset to default by the following pro-
cedure:
The display will flash 0.0.0.0 and then attempt to discover an address by DHCP. Without removing logic
power from the drive, use Workbench to connect to the drive, reconfigure the IP address settings as
desired, and store the values to non-volatile memory.
753 KOLLMORGEN | Mai 2013
NV Parameter
Sets method of acquiring IP Address.
N/A
0 to 2
0
Integer
N/A
Variant
No
Mode 0 and Mode 1 contain multiple methods of acquiring an IP Address. In these
modes each method will be implemented in the order they are listed below until an IP
Address is acquired
Mode of Acquiring IP Address
Rotary Switches, DHCP, Auto IP
IP.ADDRESS, IP.SUBNET, IP.GATEWAY
DHCP, Auto IP
Set both rotary switches to 0
l
Hold down button B1 (top-side of drive) for 5 seconds.
l
Supported
N/A
√
N/A
16 bit No