Configuration At The Lwlvision-Rem Via Osd (Adonis) - Guntermann & Drunck LwLVision-Rem Installation Und Bedienung

Guntermann & Drunck GmbH
7.2 Configuration at the LwLVision-Rem via OSD
(AdonIS)
The LwLVision system at the remote console (LwLVision-Rem) is equipped
with an OSD. Via OSD (AdonIS) you can adjust the whole system to your
needs.
With CTRL + NUM
F u n c t i o n
F2: Image Config
F3: Console Setup
F6: Config
F8: Logout
Mouse Utility
System Info
Video Info
Monitor Info
Esc
In the Function Menu the following configuration options are available:
 F2: Image Config (see
 F3: Settings at the console (see
 F6: Main configuration menu; here you can also call up Image
Config, adjust the remote monitor, compile User Accounts,
make system settings (see
F8: manual logout

 Mouse Utility: Reinitialization of the connected mouse if initialization
is lost (see
The Function Menu also delivers the following information:
 System Info: Information about the used LwLVision system
 Video Info:
Monitor Info: Information about the signals used from the monitor

you open AdonIS:
chapter
chapter 7.3)
(e.g. Revision status, keyboard/Mouse protocol, actual
user...) (see
Information about the display parameters at the signal
input of the LwLVision-PC (see
(only for DDC monitors) (see
Operating Instructions LwLVision
6.3.1)
chapter 7.2.2)
chapter 7.2.3)
chapter 7.4)
Page 24
L W L M
Enter
chapter 7.5).
chapter 7.6)