Settings In The Menu Image Config - Guntermann & Drunck LwLVision-Rem Installation Und Bedienung

Guntermann & Drunck GmbH

6.3.1.3 Settings in the menu Image Config

After you have called up Image Config you can use the following setting
possibilities for analogue video signals:
 Changing the horizontal display position (X Pos.)
Changing the vertical display position (Y Pos.)

 Tracking
 Phase
 Brightness
 Contrast
I m a g e C o n f i g
Automatic adjust:
X Pos.:
Y Pos.:
Tracking:
Phase:
Brightn.:
Contrast:
Esc
With ESC you close the Image Config menu and save the changes.
With ↑ / ↓ you can switch between the different entries.
The entries within this window have the following meaning:
Automatic Adjust:
X POS.:
Y POS.:
Tracking:
.
.
.
.
By pressing Enter the signal values are calculated by
LwLVision
Setting of the horizontal display position (left edge)
Setting of the vertical display position (top edge)
Setting of the pixels horizontal per line incl. back porch.
It calculates the scan rate at the change of analogue
video signals to digital video signals. Every pixel is to
be digitalized only once in order to get picture in focus.
If the scan frequency is not in accordance with the
video source this causes a non-focus picture with
possible missing signal data at the edges.
Page 21
Operating Instructions LwLVision
L W L M
. 306
. 39
1376
96
128
128