Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Guntermann & Drunck GmbH
8.5
Dark Switching of the Monitor
The dark switching of the non-active monitor is possible at keyboard and
mouse action and in the hold function mode but only if the dark switching was
enabled
(see chapters 7.1.6, 7.3.3.5 and
The dark switching is enabled by keyboard/mouse action or by enabling the
hold function
(CTRL
The manual hold function will be activated again by pressing
second time. The monitor of the inactive workstation will be released again
after the Time-Out (see
In default the "dark switching" is not released. If you intend to activate
the "dark switching" proceed as described in
7.2.3.3.6.
8.6
Dark Switching of the Monitor in the
Protected Mode
Another form of the dark switching results from the combination with the
Protected Mode. Basically the dark switching in the Protected Mode exactly
corresponds to the function described in
But in opposite to the dark switching (at manual hold function) all connected
monitors are switched dark in default at the Protected Mode. The default
condition is when
the Protected Mode is activated
and the dark switching is activated
If now
CTRL
and
PRINT
monitor connected to the console will be switched on. All other monitors will
stay dark.
The Protected Mode will be activated again by pressing
second time. All connected monitors will be switched dark.
In default the "dark switching" is not released. If you intend to activate
the "dark switching" proceed as described in
7.2.3.3.6.
+ PRINT).
chapter
7.3.3.8).
chapter
is pressed at one of the connected consoles the
Page 59
Operating Instructions LwLVision
7.3.3.6).
CTRL
chapters 7.2.3.3.5 and
8.5.
(see chapter
7.2.3.3.9)
(see chapters 7.2.3.3.5 and
CTRL
chapters 7.2.3.3.5 and
+
PRINT
a
7.2.3.3.6).
+
PRINT
a
Werbung
Kapitel
