Configuration Before The Start-Up; Network Port Settings - Guntermann & Drunck UCON-IP-NEO Installationsanleitung

Configuration before the start-up

Configuration before the start-up
If required, adjust the network settings of the user module and the TCP port used for
communicating with the G&D IP-Console Client software before the start-up. Thus, all
computers within the local network can access the user module.

Network port settings

The network port settings can be adjusted to the settings of the local network. The
following table lists the default network port settings:
IP assignment:
IP address
Subnet mask:
Type of connection: Auto
How to change the network settings before the start-up:
1. Use a CAT5 (or better) twisted pair cable to connect any computer to the Network
port of the user module.
2. Please ensure that the IP addresses of the computer and the user module are
assigned to the same subnet.
You can use the IP address 192.168.0.10, for example.
3. Turn on the user module.
4. Start the computer's internet browser, and enter the URL
address bar.
5. Enter the access data of the administrator account of the matrix switch in the
field of the web interface, and click on
Administration
6. Click on
Configuration
settings.
7. Enter your date on the
IMPORTANT:
new network settings have been transmitted, the defaults are reset (see above).
8. Unplug the twisted pair cable from the computer.
5 · G&D UCON-IP-NEO
static
192.168.0.1
255.255.255.0
. Now the web application shows the current configuration
tab, and click on
Server
If no user accesses the user module within 5 minutes after the
192.168.0.1
.
Login
.
Transfer to device
into the