Resetting The Defaults - Guntermann & Drunck UCON-IP-NEO Installationsanleitung

Resetting the defaults

The device provides a Reset button at the right-hand side of the Status LED. Use the
button on the front side of the user module if you want to reset the defaults.
NOTE: To prevent you from pressing the button by accident, you can only press
the button with a thin, pointy item.
How to reset the defaults:
1. Turn the user module off.
2. Press and hold the Reset button on the front side of the device.
3. Keep the button pressed and turn on the device.
4. Release the button when the Status LED starts blinking fast.
NOTE: The defaults can also be reset in the web interface.
Resetting the defaults
G&D UCON-IP-NEO · 8