Ottobock Meridium 1B1 Gebrauchsanweisung Seite 45

4.8 Notes on the safety modes
CAUTION
Using the product in safety mode
Falling due to unexpected product behaviour because of changed damping behaviour.
► The warnings/error signals (see Page 68) have to be observed.
CAUTION
Safety mode cannot be activated due to malfunction caused by water penetration or
mechanical damage
Falling due to unexpected behaviour of the product because of changed damping behaviour.
► Do not continue using the defective product.
► Contact your prosthetist immediately.
CAUTION
Safety mode cannot be deactivated
Falling due to unexpected product behaviour because of changed damping behaviour.
► If you cannot deactivate safety mode by recharging the battery, a permanent malfunction has
occurred.
► Do not continue using the defective product.
► The product must be inspected by an authorised Ottobock Service Centre. The prosthetist
is your contact person.
CAUTION
Safety signal occurs (ongoing vibration)
Falling due to unexpected behaviour of the product because of changed damping behaviour.
► Observe the warnings/error signals (see Page 68).
► Do not continue using the product after the safety signal has been emitted.
► The product must be inspected by an authorised Ottobock Service Centre. In this case, the
contact person is your prosthetist.
4.9 Information on the use of a mobile device with the cockpit app
CAUTION
Improper use of the device
Falling due to altered damping behaviour as a result of unexpected switching into MyMode.
Make sure you have been instructed in the proper use of the device with the cockpit app.
►
CAUTION
Independently applied changes or modifications made to the device
Falling due to altered damping behaviour as a result of unexpected switching into MyMode.
► Do not make any independent changes to the hardware of the device.
► Do not make any independent changes to the software/firmware of the device which are not
included in the update function of the software/firmware.
CAUTION
Improper mode switching with the device
Falling due to unexpected product behaviour because of changed damping behaviour.
Ottobock | 45