Emmaljunga Sento Bedienungsanleitung Seite 54

7) Folding the carrycot
Remove the mattress.Pull the bar using
the easy pull handle along the bottom of
the carrycot. Repeat both in the foot end
and the head end.
ERGO+ Seat unit
1) Assembly of the seat unit
1.1 Seat Frame. Press both buttons on the
sides of the footrest to unfold.
1.2 Fold out both seat attachments.
1.3 Place the seat fabric cover over the
top edge of the seat frame.
1.4 Thread the harness strap through the
seat fabric and then place the seat
fabric around the seat plate. Close
the fabric underneath the seat with
the Velcro.
1.5 Position the safety straps around the
frame and click into the buckle on the
back of the backrest. Repeat on the
left and right side of the frame.
1.6 Fasten the press studs that secure the
fabrics to the frame on both sides.
1.7 Take the straps at the bottom on the
backside of the seat unit and fasten
each one of them with the press studs
on the seat fabric according to the
picture. Make sure you click each strap
to the lowest of the press studs.
1.8 Securely attach these straps to the
seat on both sides according to the
pictures.
1.9 Ensure that both straps are securely
fastened with the press studs.
1.10 Click the back rest adjustment handle
into the bracket on both sides.
1.11 Thread the strap through the hole in
the fabric and fasten around the back
rest adjustment handle with the press
stud.
1.12 Insert the bumper bar into the
brackets on both sides of the seat
unit.
1.13 Fasten the crotch strap around the
front bar.
1.14 Attach the hood onto the seat frame
54
Pinch point - Danger of trapping.
1.15 Pull the fabric over the top of the seat
Please note:
If the hood moves up and down on
2) Attach/remove the ERGO+ seat
2.1 Engage the brake. Click the seat unit
2.2 Pull both handles on the sides
INDICATOR FOR CORRECT
FASTENING
The ERGO+ Seat is fitted with indicators
on each side to show whether the ERGO+
Seat is correctly attached.
Green=correctly attached to the chassis
Red=not correctly attached to the chassis
• Always ensure that the attachment is
• Never use the (+) seat unit on the
• Ensure that children are kept away
• Always check that the seat unit is
SENTO, SENTO PRO Carrycot+, ERGO+, FLAT+ v. 3.0
tubes at both sides.
WARNING
frame and secure with the lower press
stud. Repeat for the left and right
sides.
the seat frame tube this can cause
scratches. Ensure the seat frame tube
is free from dust and dirt.
unit
into the chassis, make sure it clicks
in properly and securely on both
sides. The seat unit can be attached
in the direction of travel or against
the direction of travel. Make sure the
indicator is completely green.
upwards and lift the seat unit off the
chassis.
WARNING
correctly connected to the frame on
both sides.
frame if one of the indicators shows
red. Both indicators must be green
before using the stroller.
from all moving parts of the pram to
avoid risk of injury.
securely fixed to the chassis before the