Angelo Po 1N0FAB Bedienungshandbuch Seite 32

ENGLISH
Even if the equipment has all its safety devices,
if necessary, during the installation and connec-
tion other safety devices may be supplemented
in accordance with applicable laws.
The illustration shows the position of the de-
vices.
Gas supply tap: for turning the connection
A)
to the gas supply line on and off .
Safety thermocouple: cuts out the gas sup-
B)
ply if the fl ame goes out.
Safety thermostat: cuts off the gas supply to
C)
the oven burner if the oven's overheats.
WARNING: Make a daily check that
the safety devices are properly installed
and in good working order.
The illustration shows the position of the signs
provided.
Nameplate with manufacturer and ap-
A)
pliance data.
WARNING: read the manual carefully
B)
before carrying out any procedure.
WARNING: when washing the appli-
C)
ance, do not point pressurised water jets at
internal parts.
WARNING draws attention on com-
D)
pliance with the rules. "Install in compliance
with the applicable regulations and use in
well ventilated premises only".
WARNING draws the attention on
E)
compliance with the rules. "The Manufac-
turer declines all liability in case of failure to
comply with the installation and commis-
sioning instructions".
WARNING: watch out for hot surfaces.
F)
4
SAFETY DEVICES
SAFETY AND INFORMATION SIGNS
B
B
C
E
D
F
37M3202
C B
CE Marking: it indicates that the equipment
G)
is compliant with all relevant laws applicable
to the product.
SAFETY
A
G
A
3319981_ut_GB