Angelo Po 1N0FAB Bedienungshandbuch Seite 174

ENGLISH
INSTRUCTIONS AND WARNING FOR REPLACING PARTS
NOTE
: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during instal-
lation and commissioning, adjustments and
part replacement.
WARNING
: Before carrying out any
replacement procedure, activate all the sa-
fety devices provided and decide whether
staff at work and those in the vicinity should
be informed.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
)
Undo the screws (B) and remove the control
)
panel (A).
Undo the locking screw (C).
)
Set the bush (D) in contact at the distance
)
shown in the fi gure.
Tighten the screw (C).
)
Replace the control panel (A) on completion
)
of the operation.
18
REPLACING PARTS
REPLACING THE PLATE BURNER NOZZLE
In particular, turn off the gas supply tap and
prevent access to all devices which might
cause unexpected health and safety hazards
if turned on.
If work parts have to be replaced, use origi-
nal spare parts only.
The manufacturer declines all responsibly
for injury or damage to components due to
the use of non original parts, or extraordina-
ry work on the appliance which may modify
the safety requirements without the ma-
nufacturer's authorisation. When ordering
components, follow the instructions provi-
ded in the parts catalogue.
A
C
B
REPLACING PARTS
C
D
3319981_inst_GB