Werbung
154
All manuals and user guides at all-guides.com
Anhang
Hinweise zur elektromagnetischen
Verträglichkeit (EMV)
Guidance and manufacturer's declaration – electromagnetic immunity –
IMAGE 1 HUB™ HD (22201020-1xx) and IMAGE 1 Pure HD (22202020-yyy) are intended for use in the electromagnetic environment specifi ed below.
The customer or user of the IMAGE 1 HUB™ HD (22201020-1xx) and IMAGE 1 Pure HD (22202020-yyy) should ensure that they are used in such an
EN/IEC 60601
Immunity test
test level
3 V rms
Conducted RF
IEC 61000-4-6
150 kHz to < 80 MHz
3 V/m
Radiated RF
IEC 61000-4-3
80 MHz to 2.5 GHz
Note: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and refl ection by structures, objects
and people.
a Field strengths from fixed transmitters, such as base stations for radio [cellular/cordless] telephones and land mobile radios, amateur radio, AM and
FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF
transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the unit is used exceeds the
applicable RF compliance level above, the unit should be observed to verify normal operation. If abnormal performance is observed, additional mea-
sures may be necessary, such as reorienting or relocating the unit.
b Over the frequency range 150 kHz to 80 MHz, fi eld strengths should be less than 3 V/m.
Appendix
Electromagnetic Compatibility (EMC)
Information
Table 204
for equipment and systems that are not life-supporting
environment.
Compliance level
Portable and mobile RF communications equipment should be used
no closer to any part of the IMAGE 1 HUB™ HD/IMAGE 1 Pure HD,
includ ing cables, than the recommended separation distance calcu-
lated from the equation applicable to the frequency of the transmitter.
Recommended separation distance:
d
3 V rms
d
3 V/m
d
Where P is the maximum output power rating of the transmitter in
watts [W] according to the transmitter manufacturer and d is the
recommended separation in meters [m].
Field strengths from fixed RF transmitters, as determined by an
electromagnetic site survey
level in each frequency range
Interference may occur in the vicinity of equipment marked with
the following symbol:
Anexo
Indicaciones sobre compatibilidad
electromagnética (CEM)
Electromagnetic environment - guidance
[
]
=
3
5 .
3 /
P
150 kHz to < 80 MHz
[
]
=
3
5 .
3 /
P
80 MHz to < 800 MHz
[ ]
=
7
3 /
P
800 MHz to 2.5 GHz
a
, should be less than the compliance
b
.
Werbung
