MPM MOD-48 Bedienungsanleitung Seite 43

1. Ensure the power cord is disconnected from the power source (Fig. 1).
2. Unscrew and remove the suction hose from the container by turning it counterclockwise (Fig. 2).
3. Insert the suction hose into the air outlet at the back of the container and tighten it by turning it
clockwise (Fig. 3).
4. Connect the power cord to the mains (Fig. 4).
5. Blowing can be started by pressing the power switch (Fig. 5).
6. Then press the suction button on the top cover panel or on the handle on the control panel (Fig.6)
7. Direct the suction hose at leaves or other debris (Fig.7).
SUPPORT FOR ACCESSORIES
STORAGE OF ACCESSORIES
- Aluminium tubes and accessories should be stored on the base
of the vacuum cleaner
CLEANING AND MAINTENANCE
1. Each time, prior to start any maintenance or cleaning activities,
turn off the device and remove the plug from the socket.
2. After using the device, empty, clean and dry the tank as well
as the detergent container. Moisture and contamination may
cause unpleasant odours to develop inside the container and tank.
FILTER CLEANING
a. To maintain filters efficiency, a periodical check-in
is required.
b. If the dust being sucked is very fine, the HEPA fil-
ter may need to be cleaned more often or replaced
with a new one.
c. Wash the sponge filter and the HEPA filter with
warm water without using detergent (Fig. 1, Fig. 2)
d. Cleaned filters should be allowed to dry completely
before reuse.
CAUTION! Do not put the filter in the dishwasher,
washing machine, tumble dryer, oven, microwave
oven or open fire (Fig. 3).
3. Do not let the device work for a long time; the
working time should not exceed 2 hours or other-
wise it will shorten the device usability period.
4. Stop using the device immediately if any unusual vibration, noise or smell is experienced, and
perform maintenance.
CAUTION! To achieve the best possible performance, clean the filters and the container after
each use.
CAUTION! Do not assembly wet filters – risk of damage to the vacuum cleaner.
CAUTION! Each time, prior to any maintenance or cleaning activities, turn off the device and
remove the plug from the socket. Do not submerge the device into water!
CAUTION! Do not use sharp objects, abrasive polishes, solvents or other strong chemicals for
cleaning since their use may cause damages to the device.
EN
43