Error Messages - Torqeedo Cruise 10.0 R Originalbetriebsanleitung

Error messages

24 Error messages
Drive system
Display
E 02
E 05
E 06
E 07
E 08
E09
E 21
E 22
E 23
E 30
E 32
Cause
Stator overtemperature (motor overheats)
Motor/propeller blocked
Voltage to motor is too low
Overcurrent to motor
Circuit board overtemperature
Water ingress to pylon
Incorrect calibration of remote accelerator
Magnetic sensor defective
Value range incorrect
Defective communication with motor
Defective communication with remote accelerator
What to do
After waiting for a short period (approx. 10 minutes), motor can again be
operated slowly.
Contact Torqeedo Service.
Put the main switch into the "OFF" position, and disconnect the motor ca-
ble. Release the blockage, and turn the propeller one more turn by hand.
Reconnect the motor cable.
Low charge state of battery. It may be possible to slowly restart the motor
from the Stop position.
Continue at reduced power.
Contact Torqeedo Service.
After waiting for a short period (approx. 10 minutes), motor can again be
operated slowly.
Contact Torqeedo Service.
Contact Torqeedo Service.
Recalibrate, see Chapter 21.4, "Connection of the remote accelerator
lever"
Recalibrate, see Chapter 22.2.2, "Use of the battery status display
when using external batteries"
Recalibrate, see Chapter 22.2.2, "Use of the battery status display
when using external batteries"
Contact Torqeedo service and provide error code.
Check the plug connectors of the data cables.
Check the cables.
EN DE
page 87 / 106