Eurotronic SPIRIT ZWAVE PLUS Kurzanleitung Seite 37

Pressure
piece falls
out (This
can also
cause an
E1-error)
ER1-ER3
ERR
ER1
ER2
ER3
Due to an endless
thread the
pressurepiece,
which is situated
at the bottom,
can fall out if the
device has not
been affixed on
the valve.
The error code can be cleared by pressing the
boost button.
Inclusion failed
Valve positioning
not possible
Valve not de-
tected
Valves closing
point not de-
tected
Put in the pressure
piece. The device can
be adapted by removing and
inserting the batteries. The
endless thread is rotating
now and fixes the pressure
piece again. Just install it to
the radiator and adapt
it once again.
Z-Wave Controller out of
range.
Check if the valve is
jammed.
Check if the Spirit Z-Wave
Plus is correctly mounted.
Check if the Spirit Z-Wave
Plus is correctly mounted.
EN
37